Send Inquiry x
I can help you
Send
aluminum foil strip
7075 Aluminum Plate Sheet
 
    Signi 7075 aluminum plate sheet is one of the highest strength aluminum alloys available. It has good machinability and an excellent strength to weight ratio, and it is a popular materials in applications where strength is extremely critical. 7075 aluminum plate sheet is often used for highly stressed parts, and has average corrosion resistance, improved resistance is normally obtained by cladding parts. Welding is generally not recommended. 7075 is a heat treatable grade of aluminum, and sometimes used in place of 2024.

 
    Signi 7075 aluminum plate sheet have application throughout aircraft and aerospace structures where a combination of high strength with moderate toughness and corrosion resistance are required. Typical applications are alclad skin sheet, structural plate components up to 101.6mm in thickness and general aluminum aerospace applications.
 
Alclad 7075 aluminum plate sheet
 
    Two sides cladding, nominal cladding thickness is 4% on gauges under 1.57mm, 2.5% on gauges over 1.57mm. Property values for one side clad materials are similar. 
 
    Signi 7075 aluminum plate sheet offer moderately good strength toughness relationships and are the standard of comparision for more recent 7*** series alloy developments. Alloy 7075 aluminum plate sheet are not offered with guaranteed minimum fracture toughness values.

 
Corrosion resistance
 
    Signi alloy 7075 aluminum plate sheet has been thoroughly evaluated for corrosion resistance of atmospheric weathering, stress-corrosion cracking and exfoliation in all currently available tempers. These values have been used as a standard for comparision in the development of more recent high strength aerospace alloys. Within the 7*** series of alloys, resistance to general corrosion attack, exfoliation improves significantly in the overage tempers(T7 type) compared with peak strength temper( T6). Generally, the T76 type temper is considered the exfoliation resistant temper, while the T73 type temper is considered the SCC resistant temper. It should be noted that T73 is as resistant to exfoliation as T76, but at lower strength levels. For applications where good surface appearance is required or in corrosive environments, alcald 7075 plate sheet are recommended.

 
Thermal treatment
 
    Many heat treatments and heat treating practices are available to develop optimum strength, toughness and other desirable characteristics for proper application of alloy 7075 aluminum plate sheet products.
 
Alloy: 7075
Temper: O, T6, T651, T62, T652, T76, T7651, T73,T7351
Stretching capacity: 300000m2, supposed width is 2000mm, then the maximum thickness is 150mm.
Thickness: 1.0mm--300mm
With: 500mm--3000mm
Length: 1000mm--12000mm
Surface: Mill finish, Bright finish, paper interleaved, one side film, both sides film.



Chemical Properties
Alloy Si Fe Cu Mn Mg Cr Ni Zn Ti Ga V Others Aluminium
min.
Each Total
7075 0.4 0.5 1.2-2.0 0.3 2.1-2.9 0.18-0.28 - 5.1-6.1 0.2 - - 0.05 0.15 Remainder